STE-175 plastic scrap recycled machine

Detailed introduction to STE-175 plastic scrap recycled machine:

Automatic scrap edge recycling machine: on the condition of the normal functioning of the system, the extruder (membrane, sticking plaster, flat yarn, sheet, plate) can produce qualified products and more than two lines of scrap edges into granulator, then, put all of the granulated edge into feed gate of extruder immediately. Mix the granulated material and raw material proportionally, and make them extrusion molding by putting them into twist bar. In this way, it can produce high-quality products which also could be recycled and reused. Recycle 100% rim charge swiftly; prevent the rim charge to be contaminated by virtue of oxidation and moisture; prevent the product to be damaged in terms of hardness, stress and color; hence, promote the quality of the product.

Each type of "Automatic scrap edge recycling machine" meet exacting requirement and it will provide you high-quality granulating-recycling technique, efficient recycling rate and longer service life. Our continual development of products and wholehearted service for our customs will make your plastic degraded material recycling be on the cutting edge of granulating-recycling technique.Our customers and friends call it edge plastic-recycling expert!

Using: 0.8-2.0mm soft& hard rim charge, e.g. PP. PE. PVC. PS. ABS materials. Function: swiftly draw the crash bag or feed it into the peck directly.1, for small or blown film extrusion machine (￠ 40MM Screw Extruder above), wider PP, PE, HIPE, LOPE, shrink film, cling film, bubble film. Thickness in the 0.01-0.08MM, the width of 30MM film side of the following materials, the application of BAT-123, BAT-163 draw-type models    2, above ￠ 100MM Screw Extruder, Blown Film Machine, for the thicker, wider, faster PP, PE, PVC, ABS `````` rigid sheet such as, thickness 0.06-3.0MM, 350MM width for the following BAT-180, BAT-250, BAT-400 primers check-type models