a test apparatus as shown in IEC60065 Figure 11.
Detailed introduction to Apparatus for abrasion test on insulation sleeves of plug pins:
Apparatus for abrasion test on insulation sleeves of plug pins
Product details: Model ZLT-CTZ1:
The beam is loaded so that the wire exerts a force of 4 N on the pin.
The plug is moved backwards and forwards in a horizontal direction in the plane of the axis of the beam, so that the wire rubs along the pin. The length of the pin thus abraded is approximately 9 mm, of which approximately 7 mm is over the insulating sleeve. The number of movements is 20 000 (10 000 in each direction) and the rate of operation is 30 movements per minute.
The test is made on one pin of each specimen.
After the test, the pins shall show no damage which may affect safety or impair the further use of the plug, in particular, the insulating sleeve shall not have punctured or rucked up.
|
Power Supply |
220V 50Hz or 115V 60Hz |
|
Number.of Test |
1~999999 |
|
Rate of Abrading |
30±1 movements per minute |
|
Load |
4-0.1N |
|
Number of Test Station |
ZLT-CTZ1:1,ZLT-CTZ2:2 |
|
Conforms to standard |
IEC884Figure28,VDE0620 Bile 29,EN50075Fig9,BS1363 Fig 9 |